Numerical simulation study on parallel high-speed vertical water entry of cone-shaped double vehicles

Objectives The cross-medium "swarm" penetration of multiple vehicles has increasingly drawn significant attention from researchers worldwide. To investigate the mutual interference phenomena between two vehicles during high-speed water entry, numerical simulation is performed to analyze the high-speed water entry process of two parallel cone-shaped vehicles under varying spacing conditions. Methods The present numerical model is based on the software of Star CCM+. The turbulence calculations were performed using the Realizable k-ε turbulence model based on the Reynolds Averaged Navier-Stokes (RANS) approach. The Volume of Fluid (VOF) multiphase flow technique was employed to model multiple fluids (air, water, and water vapor) within the same continuous medium to capture the motion of free surfaces. The Schnerr-Sauer cavitation model was employed to calculate the vapor volume fraction of water vapor to account for the phase change between water vapor and liquid. Additionally, the overset grid technology was applied to track the motion of the cylindrical projectile. The study explores the hydrodynamic characteristics, including the evolution of cavity shape, the pressure load on the head, and the motion trajectory of two parallel vehicles during water entry under different spacings (d) between two vehicles. Results When the vehicle comes into contact with the surface, the load on the vehicle and the impulsive pressure on the head increase dramatically and reach their maximum instantaneously under different spacings, then they quickly decrease. At a spacing of (d = 0.8D), the maximum impact load is more than 20% greater than that at (d = 1.6D), and the corresponding maximum impact pressure on the head has a slight increase, where (D) is the diameter of the vehicle. However, when ( d≥1.6D ), the spacing has almost no effect on the maximum load and pressure on the vehicle. During the water entry process, the pressure distribution on the inner and outer sides of the heads of the dual-body vehicles becomes unbalanced. The smaller the spacing, the more significant this mutual influence becomes, leading to greater load differences between the two sides. The cavity shape develops freely on the outer side but is restricted on the inner side due to interference. Consequently, the tail of the vehicle is tilted inward and produce a tail slap phenomenon. However, as the spacing increases, the development and evolution trends of the internal cavities of the dual-body vehicles become more gradual. Conclusions When the dual-body vehicle structure enters the water in parallel, the trend of cavity development increases. The degree of interference from adjacent projectiles is closely related to the distance between them. The present numerical study provides certain engineering guidance for the load assessment of dual-body vehicles during high-speed vertical water entry.